Hello,
The Swift 1600 gearbox conversion (Ex Jimmys Turbo Baleno) has begun.





I will update and post more pictures as the job progresses.

Cheers,
Damian

hey Damian,

Thats good to see that you have started the conversion.

If you run into any problems. u can give me a buzz and ill try to help u out. But should be straight forward.

Hello,
The gearbox, clutch and flywheel are now out of the car.



I still have to remove driveshafts but after that the fun begins with cutting the hole in the firewall.

hi damiam,

if you want i can send you a pic of where to cut the whole in the firewall.

and also your other stuff is not far off, re-moving wiring looms is a major pain

Thanks Tim,
I am quite sure where the hole needs to go but a photo would be nice.

No rush on all that stuff... to be honest I thought you had forgotten or were not bothering.

just got to get one more ecu loom out than thats it